Part Of The Operation Of The Blister Packaging Machine-richpacking020.com

Blog

Tags

Part of the Operation of the Blister Packaging Machine

Feb 22, 2022

The installation of PVC rigid sheet and aluminum foil roll on the blister packaging machine: remove the compression nut and stopper sleeve on the film reel, put the PVC rigid sheet or aluminum foil roll on the adjustment sleeve, install the stopper sleeve and compression nut and Tighten the compression nut so that the film roll cannot be loosened and rotated on the adjusting sleeve; loosen the back cap and turn the adjusting nut to align the center of the PVC roll with the center of the heat-sealing roller (250mm from the body), and use a steel plate for installation The inner side of the measuring roll is 125mm away from the body; adjust the tightness of the brake screw, the tension of the PVC roll is adjusted at 0.5~1kg tension, and the tension of the aluminum foil coil is adjusted at 1~2kg tension.

Place the PVC plastic belt through the upper and lower heating plate molds to the indexing feed roller and press the pressure roller. After the temperature and pressure meet the requirements, press the start button to work. At this time, the blister machine will start after a delay of 3 seconds. After that, the position of the indexing feed roller should be corrected according to the blister belt after positive pressure forming, so that the blister is loaded into the blister of the feed roller, aligned with the distance between the two plates, pressed on the pressure roller, and pulled out. Form a bubble tape of about two meters. When the upper and lower molds are separated, press the stop button to stop; measure with a steel ruler, when the length of the formed bubble tape is the same as the circumference of the feed roller or about minus 1mm, and then press Start the button to test blow the PVC plastic tape into a nest with a length of 4 meters, and prepare for the next step.

Blistering Machine For Capsules

The blister tape formed by the positive pressure of the flat plate is passed around the guide roller to the filling platform, and the blister is pressed into the pocket of the heat-sealing roller, pressed onto the pocket pressure-guiding roller, and the aluminum foil is laid. When the temperature of the anilox roller reaches, the rotating heat Turn the sealing clutch knob to ON, press the start button of the packaging blister machine to work, and when the heat-sealed aluminum-plastic blister tape is pulled out 1.5 meters, press the stop button to stop.

Rich Packing Pharmaceutical & Packing Machinery Provide Door-To-Door Overseas Service, All Products In Stock, Guaranteed For 3 Years! Free Maintenance For Life time!

Contact & Advisory
Email : manager@richpacking.cn
WeChat & Whatsapp & Line
+8613826093596
Address
Building D, No. 226, Beishan Qiaotou Street, Haizhu District, Guangzhou City,Guangdong Province,China

Follow Us

Hot Tags

Leave A Message

Social icons :

IPv6 network supported

Aluminum Plastic Aluminum Aluminum Blister Packing Machine

Selection Analysis of Blister Packaging Machine